victoria visors

[art ebeling]

How are the visor brackets attached to the visors on a Victoria?

[Bill Cilker]

Art
Rivets were used
I will send you pictures tomorrow

[jw hash]

they use hollow rivets similar to hood handle rivets but a different size. I just mounted some up last week. Art if you need some rivets let me know, I have the correct size.

[art ebeling]

Originally Posted by jw hash

they use hollow rivets similar to hood handle rivets but a different size. I just mounted some up last week. Art if you need some rivets let me know, I have the correct size.

I tried some from Lebaron Bonney that are too short. They are 1/8 diameter 5/16 long nickle plated tubular rivets. I could not get them to go thru the visor and bracket and leave anything to roll over. What did you use? Thank you for your offer, i sent a PM Art

[Mike V. Florida]

Look up larger rivets they are available from many sources.

[art ebeling]

Sponsored Links (Register now to hide all advertisements)

I found some 1/8” x 7/16 nickle plated tubular rivets at an office supply store and ordered them. Thanks for the responses. Art

[Oldbluoval]

They paint brown on the visor side (bout the same as seat frame).

[Bill Cilker]

Art
here are pictures of my cars sun visors. My sun visor bracket is the more common style. The one in the other post is not seen as often.

[quickchange]

our new slant visor bracket in s/steel is en route to us for inspection, once viewed we will have them produced , We will advise which dealer in USA will stock them, This has been a 13 month mission & not over yet , But looks like we are going to get there , Good things take time ?

[art ebeling]

Originally Posted by quickchange

our new slant visor bracket in s/steel is en route to us for inspection, once viewed we will have them produced , We will advise which dealer in USA will stock them, This has been a 13 month mission & not over yet , But looks like we are going to get there , Good things take time ?

Can the stainless steel be nickle plated?

[quickchange]

Art not totally sure , have seen it done by mistake , Can you tell the difference between the two , Im sure someone will advise here , Thanks, Summer is back in NZ ,

[jw hash]

if it is 304 stainless when polished out the color is pretty much dead on.

[quickchange]

Thanks for that , I knew someone would speak up, We decided stainless as would be close too Nickel & better than plating, Thanks

[Bob Bidonde]

Here are the visor locations and installations:

[Nelson C]

Do any of you gentlemen know if the Victoria visors & brackets are the same as used in a 1931 S/W Fordor Sedan?

How can we find out when the reproduction brackets will become available?

Thank you.

[160B]

Originally Posted by Nelson C

Do any of you gentlemen know if the Victoria visors & brackets are the same as used in a 1931 S/W Fordor Sedan?

How can we find out when the reproduction brackets will become available?

Thank you.

They are the same. See attached photos of visors in a 1931 S/W.

[jw hash]

160B
on the 31 SW 4 doors the visors are attached to a block of wood that goes between two of the top bows. on the Victoria`s there is a bigger top bow that the visors are attach too. I just installed the visors in Robert`s 160C yesterday.