|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
10-13-2014, 09:27 PM | #1 |
Senior Member
Join Date: May 2010
Location: Snohomish, WA
Posts: 401
|
more roadster help needed
Working on a 29 roadster and have another question.
There has to be some kind of doubler or nut plate that goes behind the A pillar where the windshield posts go that allow the post screws to thread into. What does it look like? I can certainly make something but it would be nice to have an idea what Henry did. Thank you. I have attached a couple of pics of my reproduction body. A picture of what it's supposed to look like would be nice if anyone has one. |
10-13-2014, 11:48 PM | #2 |
Senior Member
Join Date: May 2010
Posts: 1,643
|
Re: more roadster help needed
Here's what the originals looked like. The two outer holes are threaded and the middle one is used to rivet it in place. The bolt holes are not parallel on either plane so might be tricky to make up. I would check with Brookville - they must have something to use there.
- |
Sponsored Links (Register now to hide all advertisements) |
|
10-14-2014, 09:01 AM | #3 |
Senior Member
Join Date: May 2010
Location: Snohomish, WA
Posts: 401
|
Re: more roadster help needed
Sponsored Links (Register now to hide all advertisements)
|
|
|
Sponsored Links (Register now to hide all advertisements) |
|