|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
03-19-2019, 08:40 PM | #1 |
Senior Member
Join Date: May 2010
Location: Lexington, NC
Posts: 861
|
Remote door handle spring install
Does anyone know of a special "trick" for installing the spring on the remote (handle) end of a door latch assembly? I was wondering if it can be done without heating the tabs and removing the mechanism cover. I'm working on a '37 pickup.
|
03-19-2019, 09:01 PM | #2 |
Senior Member
Join Date: May 2010
Location: East Hartford, Ct
Posts: 5,898
|
Re: Remote door handle spring install
Sponsored Links (Register now to hide all advertisements)
Using a sharp chisel to start opening the tabs then a larger screw-driver like device to further open until able to grasp with vice grips to fully straighten. If any tabs break off a simple tack weld will secure the plate to the body.
__________________
DON'T RECALL DOING SOMETHING FOR MYSELF BASED ON SOMEONE ELSE'S LIKES OR DISLIKES Last edited by 51 MERC-CT; 03-19-2019 at 09:11 PM. |
Sponsored Links (Register now to hide all advertisements) |
|
|
|
Sponsored Links (Register now to hide all advertisements) |
|