|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
02-27-2020, 04:44 PM | #1 |
Senior Member
Join Date: May 2010
Location: Wisconsin, USA
Posts: 8,935
|
Help ID hood trim please
Guys, I could use some help here please.
All four pieces are about 1/2" wide. The two short pieces are each about 33 1/2" long and have speared ends. The two long pieces are about 51 1/2" long and have one spear end and one "flat' end. What say you? Thanks.
__________________
"I can explain it for you. However, I can't understand it for you". |
02-27-2020, 04:53 PM | #2 |
Senior Member
Join Date: May 2010
Location: upstate SC
Posts: 2,962
|
Re: Help ID hood trim please
on the flat end are they slanted? look like 39 deluxe hood trim but maybe zepher ??
|
Sponsored Links (Register now to hide all advertisements) |
|
02-27-2020, 04:55 PM | #3 | |
Senior Member
Join Date: May 2010
Location: Wisconsin, USA
Posts: 8,935
|
Re: Help ID hood trim please
Quote:
I thought 39 deluxe trim was just a tad wider. No? Maybe about 5/8". I wish I had a car close by to compare. What ya think?
__________________
"I can explain it for you. However, I can't understand it for you". |
|
02-27-2020, 08:34 PM | #4 |
Member
Join Date: May 2010
Location: Wisconsin,USA
Posts: 97
|
Re: Help ID hood trim please
Mike: Look on Ebay. There is currently a 39 Deluxe hood with trim that looks like your photo.
|
02-27-2020, 09:40 PM | #5 |
Senior Member
Join Date: May 2010
Location: Minnesota
Posts: 543
|
Re: Help ID hood trim please
Mike the I measured a pair of lower 39 Deluxe Ford hood moldings and I get about 34 15/16” x 5/8” see attached.
|
02-27-2020, 10:11 PM | #6 |
Senior Member
Join Date: May 2010
Location: Wisconsin, USA
Posts: 8,935
|
Re: Help ID hood trim please
Sponsored Links (Register now to hide all advertisements)
__________________
"I can explain it for you. However, I can't understand it for you". |
Thread Tools | |
Display Modes | |
|
|
Sponsored Links (Register now to hide all advertisements) |
|