The Ford Barn

Tom Bellfoy · 03-03-2017, 01:10 PM

I am converting my 31 model A to hydraulics using 39-48 hubs and backing plates 12 inch drums. Is there a special rear wheel bearing for this or do I have to install the drums onto my Model A hubs ?

redmodelt · 03-03-2017, 01:17 PM

Sponsored Links (Register now to hide all advertisements)

Ask in the Model A section. You use the 36 to 48 bearings. The race on the axle is the same but ID of the hub is smaller.

03-03-2017, 01:10 PM	#1
Tom Bellfoy Senior Member Join Date: Oct 2010 Location: Cumberland, ON Posts: 252	rear hubs for Model A for using 39-48 hydraulics I am converting my 31 model A to hydraulics using 39-48 hubs and backing plates 12 inch drums. Is there a special rear wheel bearing for this or do I have to install the drums onto my Model A hubs ?

03-03-2017, 01:17 PM	#2
redmodelt Senior Member Join Date: May 2010 Location: Portland OR Posts: 6,340	Re: rear hubs for Model A for using 39-48 hydraulics Sponsored Links (Register now to hide all advertisements) Ask in the Model A section. You use the 36 to 48 bearings. The race on the axle is the same but ID of the hub is smaller. __________________ I know the voices aren't real but damn they have some good ideas!

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode