Go Back   The Ford Barn > General Discussion > Early V8 (1932-53)

Sponsored Links (Register now to hide all advertisements)

Reply
 
Thread Tools Display Modes
Old 03-03-2017, 01:10 PM   #1
Tom Bellfoy
Senior Member
 
Tom Bellfoy's Avatar
 
Join Date: Oct 2010
Location: Cumberland, ON
Posts: 248
Default rear hubs for Model A for using 39-48 hydraulics

I am converting my 31 model A to hydraulics using 39-48 hubs and backing plates 12 inch drums. Is there a special rear wheel bearing for this or do I have to install the drums onto my Model A hubs ?
Tom Bellfoy is offline   Reply With Quote
Old 03-03-2017, 01:17 PM   #2
redmodelt
Senior Member
 
redmodelt's Avatar
 
Join Date: May 2010
Location: Portland OR
Posts: 5,274
Default Re: rear hubs for Model A for using 39-48 hydraulics

Sponsored Links (Register now to hide all advertisements)
Ask in the Model A section. You use the 36 to 48 bearings. The race on the axle is the same but ID of the hub is smaller.
__________________
I know the voices aren't real but damn they have some good ideas!
redmodelt is offline   Reply With Quote
Sponsored Links (Register now to hide all advertisements)
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 10:07 AM.