04-01-2019, 07:03 PM | #21 |
Senior Member
Join Date: May 2010
Posts: 4,482
|
Re: 39 rake
That torque tube seal looks like a high labor job to install?
|
04-01-2019, 07:50 PM | #22 |
Senior Member
Join Date: Aug 2012
Location: Perth, Western Australia
Posts: 2,687
|
Re: 39 rake
I run 7.50 on the back and 5.50 up front Ive not had a diff oil drain issue. However in the garage I have small ramps for the front about an inch high.
__________________
"Came too close to dying to stop living now!" |
Sponsored Links (Register now to hide all advertisements) |
|
04-01-2019, 07:55 PM | #23 |
Senior Member
Join Date: May 2010
Location: Coral Springs FL
Posts: 10,941
|
Re: 39 rake
This will cause an oil drain problem from the rear. 5:60 x 15 on front. 7:60 x 15 on rear.
4 inch dropped axle. Bottom of chin pan is 4 1/2 in. off ground. Not complaining, just saying. |
04-01-2019, 07:56 PM | #24 |
Member Emeritus
Join Date: Nov 2012
Location: Wichita KS
Posts: 16,132
|
Re: 39 rake
|
04-01-2019, 08:08 PM | #25 |
Senior Member
Join Date: Apr 2014
Location: Minnesota
Posts: 1,166
|
Re: 39 rake
Shorter spring shackles with a panhard bar to keep things from swaying.
Last edited by 38bill; 04-01-2019 at 08:13 PM. |
04-03-2019, 10:13 AM | #26 |
Senior Member
Join Date: May 2010
Location: Coral Springs FL
Posts: 10,941
|
Re: 39 rake
Sponsored Links (Register now to hide all advertisements)
https://www.fordbarn.com/forum/showt...center+bearing |
|
|
Sponsored Links (Register now to hide all advertisements) |
|