Go Back   The Ford Barn > General Discussion > Early V8 (1932-53)

Sponsored Links (Register now to hide all advertisements)

Reply
 
Thread Tools Display Modes
Old 01-16-2019, 02:59 PM   #1
AnthonyG
Senior Member
 
AnthonyG's Avatar
 
Join Date: May 2013
Location: Pa.
Posts: 2,161
Default Dark brown gravy for oil

Just getting around to changing the oil in by 8BA after last season. Tried to start to heat oil up before oil change but battery low so turned fairly slow & wouldn't start. Tried priming and choking for a while & figured i had it flooded so let it go for a couple of days & charged the battery. Second try 3 days later fired right up let it get to 150 shut down and drained oil. Noticed it was like dark brown gravy. didn't smell antifreeze but did smell like over rich exhaust. Made me recall the exhaust smelled pretty rich even after running a bit. Can gas in the crank case cause the oil to get dark brown and a bit creamy or just water? I've had a few blown head gaskets in my history but always was a lighter color creamy brown like chicken gravy or lighter. Thjoughts?
__________________
Nomad

Last edited by AnthonyG; 01-16-2019 at 03:06 PM.
AnthonyG is offline   Reply With Quote
Old 01-16-2019, 03:04 PM   #2
51 MERC-CT
Senior Member
 
51 MERC-CT's Avatar
 
Join Date: May 2010
Location: East Hartford, Ct
Posts: 5,898
Default Re: Dark brown gravy for oil

Sounds normal to me
__________________
DON'T RECALL DOING SOMETHING FOR MYSELF BASED ON SOMEONE ELSE'S LIKES OR DISLIKES
51 MERC-CT is offline   Reply With Quote
Sponsored Links (Register now to hide all advertisements)
Old 01-16-2019, 03:35 PM   #3
AnthonyG
Senior Member
 
AnthonyG's Avatar
 
Join Date: May 2013
Location: Pa.
Posts: 2,161
Default Re: Dark brown gravy for oil

Maybe. I did run it a lot more this season. Normally change at the end of each season as I don't run a filter. I've done 5 or 6 changes since build & just thought it looked different. Usually black and thinner consistency. Guess I'll go ahead with the change and check again after running a bit just to make sure.
__________________
Nomad
AnthonyG is offline   Reply With Quote
Old 01-16-2019, 06:57 PM   #4
Talkwrench
Senior Member
 
Talkwrench's Avatar
 
Join Date: Aug 2012
Location: Perth, Western Australia
Posts: 2,687
Default Re: Dark brown gravy for oil

Probably haven't run it enough.. Makes sure its at operating temp when you dump it.. Then wait for it to cool down a little and jamb your finger up in there and have a good feel around, see how much sludge you got ..or metal if things aren't what they should be
__________________
"Came too close to dying to stop living now!"
Talkwrench is offline   Reply With Quote
Old 01-16-2019, 07:10 PM   #5
J Franklin
Senior Member
 
J Franklin's Avatar
 
Join Date: May 2010
Location: Oregon
Posts: 5,947
Default Re: Dark brown gravy for oil

No filter means you need to change more often.
J Franklin is offline   Reply With Quote
Old 01-17-2019, 04:20 AM   #6
Oldbluoval
Senior Member
 
Oldbluoval's Avatar
 
Join Date: Jun 2015
Location: Signal Mtn, TN (SE TN)
Posts: 2,360
Default Re: Dark brown gravy for oil

Sponsored Links (Register now to hide all advertisements)
My experience has been water in the oil.
Head leak or worse crack somewhere
Oldbluoval is offline   Reply With Quote
Old 01-17-2019, 04:46 AM   #7
flatheadmurre
Senior Member
 
flatheadmurre's Avatar
 
Join Date: Apr 2015
Location: Sweden
Posts: 3,045
Default Re: Dark brown gravy for oil

Short trips when engine don´t get up to full working temp for an extended period can give you condensation with sludge as result...so before fearing the worst change oil and take it for a long nice drive.
I see this alot on modern cars to that just drives 10min to the mall and back.
flatheadmurre is offline   Reply With Quote
Old 01-17-2019, 08:12 AM   #8
Frank Miller
Senior Member
 
Frank Miller's Avatar
 
Join Date: May 2010
Location: Auburn, MA
Posts: 2,106
Default Re: Dark brown gravy for oil

The water temp does not equate to the oil temp. You really need to drive it for about 20 minutes to get it up to temp.
__________________
“The technique of infamy is to start two lies at once and get people arguing heatedly over which is true.” ~ Ezra Pound
Frank Miller is offline   Reply With Quote
Old 01-17-2019, 08:28 AM   #9
Gene1949
Senior Member
 
Gene1949's Avatar
 
Join Date: Jun 2016
Location: Pahrump, NV
Posts: 372
Default Re: Dark brown gravy for oil

Frank Miller X2

I'm guilty also. I've had carb gasket issues (shrinkage) until I start them once a week for about 10 minutes and then the following week the 20 minute drive.

The Ford with the 4GC isn't too bad but the 69 Camaro with the Demon (Holly clone) is really susceptible to gasket shrinkage.
Gene1949 is offline   Reply With Quote
Old 01-17-2019, 09:19 AM   #10
JSeery
Member Emeritus
 
JSeery's Avatar
 
Join Date: Nov 2012
Location: Wichita KS
Posts: 16,132
Default Re: Dark brown gravy for oil

Anthony, I don't remember, are you running thermostates? Any engine needs to get up to a high enough temperature to remove the condensation out of the oil. A lot of starting the engine up and running it for a short time so it doesn't get up to a high enough oil temperature can result in a build up of condensation in the oil.
JSeery is offline   Reply With Quote
Old 01-17-2019, 12:13 PM   #11
AnthonyG
Senior Member
 
AnthonyG's Avatar
 
Join Date: May 2013
Location: Pa.
Posts: 2,161
Default Re: Dark brown gravy for oil

Thx, even though I been working vehicles 4 yrs not so much on Flatty’s. Only have the one & hasn’t needed much since installing in my ‘35. Always good to hear from experience @ FB! Let oil drain with plugs out for a few days to air out. Probably change tomorrow along w aluminum powder sealer Kube suggested in another thread for sealing up minor internal coolant leaks. Then weather permitting take a long drive! Checking oil along the way.
__________________
Nomad
AnthonyG is offline   Reply With Quote
Old 01-17-2019, 01:00 PM   #12
AnthonyG
Senior Member
 
AnthonyG's Avatar
 
Join Date: May 2013
Location: Pa.
Posts: 2,161
Default Re: Dark brown gravy for oil

Any recommendations on which to use aluminum powder base, copper powder base or Barr’s has a new carbon fiber base internal coolant sealant?
__________________
Nomad
AnthonyG is offline   Reply With Quote
Old 01-17-2019, 01:08 PM   #13
philipswanson
Senior Member
 
Join Date: Oct 2015
Location: Bonita, CA
Posts: 1,374
Default Re: Dark brown gravy for oil

Run a good synthetic oil like Shell Rotella or High Mileage Mobil I. Change as often as you need to keep the oil clean. You should be able to read the dip stick through the oil. Get the dirty oil analyzed.
philipswanson is offline   Reply With Quote
Old 01-17-2019, 06:19 PM   #14
Bored&Stroked
Senior Member
 
Bored&Stroked's Avatar
 
Join Date: Jan 2011
Location: Central Ohio
Posts: 5,013
Default Re: Dark brown gravy for oil

I wouldn't put the block sealer in until you know you have an issue . . . no reason to fix a problem you may not have.
Bored&Stroked is offline   Reply With Quote
Old 01-17-2019, 07:23 PM   #15
Jack E/NJ
Senior Member
 
Jack E/NJ's Avatar
 
Join Date: May 2010
Posts: 2,171
Default Re: Dark brown gravy for oil

Yeah. GM used to add an old bar stopleak tablet or two to each one of their brandy new vehicle coolant systems as a preventative measure. And looked what happened to GM. 8^) Jack E/NJ
Jack E/NJ is offline   Reply With Quote
Old 01-18-2019, 10:35 AM   #16
AnthonyG
Senior Member
 
AnthonyG's Avatar
 
Join Date: May 2013
Location: Pa.
Posts: 2,161
Default Re: Dark brown gravy for oil

JS, I don’t use Stats in warm weather & usually run it minimally in winter. I realize they like to run a bit hot but always had a problem in warm weather keeping it from under 210 degrees w Stat’s. Engine has been prone to this since new. Read started many threads & assumed after nothing worked except no Stats that block had internal semi blockage issues. Many flushes and many products later I gave up & no stats worked in warm weather so stayed with. Your right in thinking it doesn’t reach temp in the winter so starting & running for 30 mins every couple weeks could have caused the condensation issue.
Thx
__________________
Nomad
AnthonyG is offline   Reply With Quote
Old 01-18-2019, 10:39 AM   #17
AnthonyG
Senior Member
 
AnthonyG's Avatar
 
Join Date: May 2013
Location: Pa.
Posts: 2,161
Default Re: Dark brown gravy for oil

Probably should put stats if running at all in cold weather.
__________________
Nomad
AnthonyG is offline   Reply With Quote
Old 01-18-2019, 10:51 AM   #18
FRANK PKNY
Senior Member
 
FRANK PKNY's Avatar
 
Join Date: May 2010
Location: POUGHKEEPSIE NY 12601
Posts: 1,016
Default Re: Dark brown gravy for oil

Water is the cause, either it's not getting hot enough, or you have a leak, gasket, crack. Et. Try a pressure test. Should help you evaluate the condition of your cooling system. Easy to do, won't hurt anything.
__________________
FRANK PKNY is offline   Reply With Quote
Old 01-18-2019, 01:42 PM   #19
flatjack9
Senior Member
 
flatjack9's Avatar
 
Join Date: May 2010
Location: Oshkosh, Wi
Posts: 4,516
Default Re: Dark brown gravy for oil

Quote:
Originally Posted by AnthonyG View Post
JS, I don’t use Stats in warm weather & usually run it minimally in winter. I realize they like to run a bit hot but always had a problem in warm weather keeping it from under 210 degrees w Stat’s. Engine has been prone to this since new. Read started many threads & assumed after nothing worked except no Stats that block had internal semi blockage issues. Many flushes and many products later I gave up & no stats worked in warm weather so stayed with. Your right in thinking it doesn’t reach temp in the winter so starting & running for 30 mins every couple weeks could have caused the condensation issue.
Thx
There is your problem. Running the engine like that is one of the worst things you can do to an engine. The oil never gets warm enough to cook the moisture out. Most of the wear to any engine is during initial startup and running. Thermostats are needed to warm the engine faster to negate the wear. Quit doing that and you will be just fine. Your engine will thank you.
flatjack9 is offline   Reply With Quote
Old 01-18-2019, 03:37 PM   #20
AnthonyG
Senior Member
 
AnthonyG's Avatar
 
Join Date: May 2013
Location: Pa.
Posts: 2,161
Default Re: Dark brown gravy for oil

What's the pn# of the Subaru thermostats I see people using.
__________________
Nomad
AnthonyG is offline   Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 03:15 AM.