|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
02-13-2018, 12:38 PM | #21 |
Senior Member
Join Date: May 2010
Location: So Cal
Posts: 8,750
|
Re: unusually headlight issue
Here's a picture Mike V posted.
Bob Last edited by Bob C; 02-16-2018 at 12:29 PM. |
02-13-2018, 01:15 PM | #22 |
Senior Member
Join Date: Jun 2010
Location: San Diego, CA
Posts: 1,486
|
Re: unusually headlight issue
Y-Blockhead and Tom are both correct.
|
Sponsored Links (Register now to hide all advertisements) |
|
02-16-2018, 12:00 PM | #23 |
Senior Member
Join Date: Aug 2012
Posts: 880
|
Re: unusually headlight issue
Yes, Low beam filament should be on top. I read on Ford Barn a while back that if you put the brighter filament on the top, using the 50cp filament for low beam, and then tie the high and low filaments together the result is a 82cp for high beam (50cp +32cp=82).
That is what Ron Francis recommends for his Super Bright Bulbs resulting in 75cp low beams and 125cp high beams (75cp +50cp +125cp).
__________________
The Master Cylinder Enjoying life at the beach in SoCal... |
|
|
Sponsored Links (Register now to hide all advertisements) |
|