|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
02-25-2014, 05:33 PM | #1 |
Member
Join Date: Jun 2013
Location: Stoughton, MA
Posts: 39
|
Transmission cover on 40 Ford Standard
I'm replacing the transmission cover on my 40 Ford Standard and would like to know what the correct fasteners are. I'm sure the original fasteners have been replaced. I don't think the correct setup is with the existing hexhead bolts and nuts. Does anyone know if I should be using panhead or stovehead type bolts. Also, should I use caged nut clips on the floor panel with the bolts, or, are regular nuts proper? How about any washers? Thank you all in advance for any input. Dick in MA.
|
02-25-2014, 05:36 PM | #2 | |
Senior Member
Join Date: May 2010
Location: Wisconsin, USA
Posts: 8,993
|
Re: Transmission cover on 40 Ford Standard
Quote:
If you feel you want to dig through your nuts and bolts drawer, let me know and I will post a photo of what you need.
__________________
"I can explain it for you. However, I can't understand it for you". |
|
Sponsored Links (Register now to hide all advertisements) |
|
02-25-2014, 06:14 PM | #3 |
Member
Join Date: Jun 2013
Location: Stoughton, MA
Posts: 39
|
Re: Transmission cover on 40 Ford Standard
Thx for your input, Kube. If it isn't too much to ask, would you post the photo of what I would require? I have ample supplies in my garage. I just don't know what to use as originally specified. I'd really appreciate it.
Last edited by dp1743; 02-25-2014 at 06:17 PM. Reason: Additional info added. |
03-01-2014, 12:47 PM | #4 | |
Senior Member
Join Date: May 2010
Location: Wisconsin, USA
Posts: 8,993
|
Re: Transmission cover on 40 Ford Standard
Quote:
I do not recall the exact amount of each required. All screws are 1/4". I'd attempted to depict the screws and cup washer in different views to make your search perhaps a bit easier.
__________________
"I can explain it for you. However, I can't understand it for you". |
|
03-01-2014, 01:32 PM | #5 |
Member
Join Date: Jun 2013
Location: Stoughton, MA
Posts: 39
|
Re: Transmission cover on 40 Ford Standard
Sponsored Links (Register now to hide all advertisements)
Thank you for the photo. That'll help me put mine right. It's kind of tough locating this type of correct information, but, thanks to people like you it's still possible. Hope you're weathering this winter okay, and, thanks again for your help.-Dick Last edited by dp1743; 03-01-2014 at 01:34 PM. Reason: spelling correction |
|
|
Sponsored Links (Register now to hide all advertisements) |
|