12-15-2018, 11:53 AM | #1 |
BANNED
Join Date: May 2010
Location: Walla Walla, Washington USA
Posts: 6,066
|
Spindle Arms
City:
Prescott
State:
WA
Sponsored Links (Register now to hide all advertisements)
On page 4-2 Revised 2011 of the MARC/MAFCA RESTORATION GUIDELINES and JUDGING STANDARDSand page 283 of the Ford Service Bulletins, tell us that there was a change in the dimentions of the Spindle Arms...both right and left. The change was the repositioning of the Tie Rod Arms only. I have at least 15 or so of the double ball arms at the 13/16" and about the same for the single ball arm and am in need of the 3rd type as explaned in the Standards but have none. I would of thought for sure I would of. Does anyone have a set of the 3rd type...BEFORE the change in the Tie Rod Arms themselves and at the correct measurements on 1-1/8" inch? I have one of the two ball type that could be in the ball park but is way more than the 1-1/8" that the standards and bulletins say yet it has the correct part number on the casting. More than likely this one is bent but it sure does not look it. This is also in the classifieds... Thanks. Please email me at [email protected] Pluck |
Sponsored Links (Register now to hide all advertisements) |
|
|
|
Sponsored Links (Register now to hide all advertisements) |
|