|
|||||||
| Sponsored Links (Register now to hide all advertisements) |
|
|
|
Thread Tools | Display Modes |
10-12-2017, 12:51 PM
|
#1 |
|
Senior Member
Join Date: May 2010
Location: Encino California, near Burbank
Posts: 935
|
Compressed Head Gasket?
Looking for a thick gasket for my 59A with over-shaved Weiand heads(aluminum). Went through my collection of gaskets and found the copper 3036 Victor to be the best I have in stock @ .076" minimum. I know that the Speedway big-bore boasts .070" compressed but would rather not wait for the process if the Victor would come close on my +'040" bored block. Is the Victor good enough? Thanks: Fred A
|
|
|
«
Previous Thread
|
Next Thread
»
Threaded Mode
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
All times are GMT -5. The time now is 10:50 AM.