Go Back   The Ford Barn > General Discussion > Model A (1928-31)

Sponsored Links (Register now to hide all advertisements)

Reply
 
Thread Tools Display Modes
Old 11-19-2019, 07:10 PM   #1
PC/SR
Senior Member
 
Join Date: May 2010
Location: Santa Rosa, CA
Posts: 1,154
Default Ring gear pins

What type/size/source pins do you guys use to pin the ring gear to the flywheel. The ones I got are too big. Thanks
PC/SR is offline   Reply With Quote
Old 11-20-2019, 03:15 AM   #2
SAJ
Senior Member
 
SAJ's Avatar
 
Join Date: Jul 2010
Location: Auckland, New Zealand
Posts: 352
Default Re: Ring gear pins

4 off 6 mm on one car with countersunk heads (for a nice tidy look only) and 4 off 8 mm plain Allen head grub screws on the next car then 6 off 8 mm plain Allen head grubs on a third and fourth car. Three were done on a drill press_flywheel out. The first was done through the starter hole, counting teeth to keep it balanced.
Lengths all the exact width of the ring gear to just bottom on the flywheel ledge.
SAJ in NZ

Last edited by SAJ; 11-20-2019 at 03:18 AM. Reason: Added length data
SAJ is offline   Reply With Quote
Sponsored Links (Register now to hide all advertisements)
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 09:54 PM.