The Ford Barn

PC/SR · 11-19-2019, 07:10 PM

What type/size/source pins do you guys use to pin the ring gear to the flywheel. The ones I got are too big. Thanks

SAJ · 11-20-2019, 03:15 AM

4 off 6 mm on one car with countersunk heads (for a nice tidy look only) and 4 off 8 mm plain Allen head grub screws on the next car then 6 off 8 mm plain Allen head grubs on a third and fourth car. Three were done on a drill press_flywheel out. The first was done through the starter hole, counting teeth to keep it balanced.
Lengths all the exact width of the ring gear to just bottom on the flywheel ledge.
SAJ in NZ

11-19-2019, 07:10 PM	#1
PC/SR Senior Member Join Date: May 2010 Location: Santa Rosa, CA Posts: 1,154	Ring gear pins What type/size/source pins do you guys use to pin the ring gear to the flywheel. The ones I got are too big. Thanks

11-20-2019, 03:15 AM	#2
SAJ Senior Member Join Date: Jul 2010 Location: Auckland, New Zealand Posts: 352	Re: Ring gear pins 4 off 6 mm on one car with countersunk heads (for a nice tidy look only) and 4 off 8 mm plain Allen head grub screws on the next car then 6 off 8 mm plain Allen head grubs on a third and fourth car. Three were done on a drill press_flywheel out. The first was done through the starter hole, counting teeth to keep it balanced. Lengths all the exact width of the ring gear to just bottom on the flywheel ledge. SAJ in NZ Last edited by SAJ; 11-20-2019 at 03:18 AM. Reason: Added length data

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode