|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
11-14-2020, 06:51 PM | #1 |
BANNED
Join Date: May 2010
Location: Walla Walla, Washington USA
Posts: 6,066
|
Front end tollerences...
Most of us, if not all, would like to have the front end assembly, when attached to the front cross member and measured from equal points, A to B, left and right, be almost equal.
However sometimes they are not equal. In other words, pick a point on the front end (A) and measure to a "given" point (B) on the frame, left and right. They should be equal or darn near close to it but sometimes they are not. With that said...Just how much of a tollerence is acceptable if one can not adjust the "problem", if in fact it is a problem, to get to where both sides are equal? 1/16"?, 2/16"?, 3/16"? Thanks. Pluck |
Thread Tools | |
Display Modes | |
|
|
Sponsored Links (Register now to hide all advertisements) |
|