|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
09-24-2021, 01:13 PM | #1 |
Junior Member
Join Date: Sep 2021
Location: Townsend Delaware
Posts: 11
|
1940/1941 ford cab hole question
while looking at my new cab for my 1940 ford pickup project i noticed there are 3 holes on the lower front cowl BELOW where fender bolts to. I noticed on my other 1940 cab that i sold recently it also had these holes. Can someone tell me what they were for?
|
09-24-2021, 01:30 PM | #2 | |
Senior Member
Join Date: May 2010
Location: Wisconsin, USA
Posts: 8,990
|
Re: 1940/1941 ford cab hole question
Quote:
Does yours appear similar to this one?
__________________
"I can explain it for you. However, I can't understand it for you". |
|
Sponsored Links (Register now to hide all advertisements) |
|
09-24-2021, 01:48 PM | #3 |
Junior Member
Join Date: Sep 2021
Location: Townsend Delaware
Posts: 11
|
Re: 1940/1941 ford cab hole question
Yes, i guess i should have said the 2 holes as the bottom one is for the fender.
|
09-24-2021, 02:19 PM | #4 |
Senior Member
Join Date: May 2010
Location: Solihull, England.
Posts: 8,744
|
Re: 1940/1941 ford cab hole question
I think that's where the fender attaches if the cab is used on a bigger truck than a 1/2 ton.
Mart. |
09-24-2021, 04:56 PM | #5 |
Senior Member
Join Date: May 2012
Location: Queensland, Australia
Posts: 10,350
|
Re: 1940/1941 ford cab hole question
Sponsored Links (Register now to hide all advertisements)
1940 Ford pickup cab |
Thread Tools | |
Display Modes | |
|
|
Sponsored Links (Register now to hide all advertisements) |
|