|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
07-03-2018, 05:59 AM | #1 |
Senior Member
Join Date: Sep 2010
Location: South of I-40
Posts: 379
|
59A Water Temp Sensor
Folks, would these be the right water temp sensors for a 59A Flathead, stock heads, converted to 12V. I also believe I will need adapters, can anyone recommend a source for the adapters and plug for the remaining port.
I've done a lot of research but I think I've only confused the issue. https://cgfordparts.com/ufolder/cgca...epart=8A-10990 https://cgfordparts.com/ufolder/cgca...epart=8A-10884 Thanks FORDBARN. |
07-03-2018, 06:49 AM | #2 |
Senior Member
Join Date: Sep 2013
Location: Dighton, Mass
Posts: 1,230
|
Re: 59A Water Temp Sensor
You should not need any adaptors, the treads are all the same that is if you are buying the
correct sender that go up to 1953. you only need the single terminal sender because the 337 flathead uses only one so why not just use just one. The two terminal on the left head is only a switch, it doesn't read anything all that does if too too hot, switch opens and pegs the needle on hot. |
Sponsored Links (Register now to hide all advertisements) |
|
07-03-2018, 07:05 AM | #3 |
Member Emeritus
Join Date: Nov 2012
Location: Wichita KS
Posts: 16,132
|
Re: 59A Water Temp Sensor
Sponsored Links (Register now to hide all advertisements)
Last edited by JSeery; 07-03-2018 at 09:12 AM. |
|
|
Sponsored Links (Register now to hide all advertisements) |
|