|
|||||||
| Sponsored Links (Register now to hide all advertisements) |
|
|
 |
|
Thread Tools | Display Modes |
02-09-2021, 05:54 PM
|
#1 |
|
Senior Member
Join Date: May 2010
Location: 215 E. 6th Street Northport, Michigan 49670
Posts: 941
|
Wood header question 30'
What type fasteners/screws/bolts are used to hold the wood header to the metal angle section over the windshield on a 1930 Sport Coupe???
__________________
Bob from Northport Northport, Michigan Last edited by Bob from Northport; 01-24-2022 at 09:39 PM. |
|
|
|
02-10-2021, 09:00 PM
|
#2 |
|
Senior Member
Join Date: May 2010
Location: 215 E. 6th Street Northport, Michigan 49670
Posts: 941
|
Re: Wood header question 30'
bmp
__________________
Bob from Northport Northport, Michigan |
|
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
|
02-11-2021, 09:27 PM
|
#3 |
|
Senior Member
Join Date: May 2010
Location: 215 E. 6th Street Northport, Michigan 49670
Posts: 941
|
Re: Wood header question 30'
I located the answer to my question for those that wish to know. The header is held by 5/16x18x1 3/4" Stove bolt flat head screws.
__________________
Bob from Northport Northport, Michigan Last edited by Bob from Northport; 01-24-2022 at 09:39 PM. |
|
|
|
|
02-12-2021, 12:01 PM
|
#4 |
|
Senior Member
Join Date: Dec 2011
Location: SW Idaho
Posts: 970
|
Re: Wood header question 30'
And t nuts for the front side.
|
|
|
|
|
02-12-2021, 12:11 PM
|
#5 |
|
Senior Member
Join Date: May 2010
Location: 215 E. 6th Street Northport, Michigan 49670
Posts: 941
|
Re: Wood header question 30'
Sponsored Links (Register now to hide all advertisements)
__________________
Bob from Northport Northport, Michigan |
|
|
|
|
«
Previous Thread
|
Next Thread
»
| Thread Tools | |
| Display Modes | |
Linear Mode
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
All times are GMT -5. The time now is 04:10 AM.