|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
07-25-2018, 01:27 PM | #1 |
Senior Member
Join Date: Apr 2011
Location: Endeavor, WI
Posts: 119
|
Windshield Blocked by Gascap...
Should the windshield open all the way without contacting the fuel cap?
If I remove the cap I can open the window the rest of the way. Perhaps I have a non-OEM item. I just learned that the gasket of the original should be leather, but I don't remember what mine has.
__________________
"I have not yet begun to defile myself." -Doc Holliday '31 Tudor, '69 F100, '66 Mustang, '11 Ford Flex |
07-25-2018, 01:29 PM | #2 |
Senior Member
Join Date: May 2010
Location: Tacoma, WA
Posts: 1,025
|
Re: Windshield Blocked by Gascap...
Yup. Sounds like your header over the windshield is going bad. You might get lucky and be able to tighten up the windshield upper frame screws.
|
Sponsored Links (Register now to hide all advertisements) |
|
07-25-2018, 01:31 PM | #3 |
Senior Member
Join Date: Jul 2010
Location: Pennsylvania
Posts: 1,096
|
Re: Windshield Blocked by Gascap...
Might be your header, but some of the repro gas caps are too high.
|
07-25-2018, 02:35 PM | #4 |
Senior Member
Join Date: May 2010
Posts: 332
|
Re: Windshield Blocked by Gascap...
I had a reproduction gas cap that would not let the windshield move past the cap because it sat to high . I put a original on and the clearance was just right . I had all new header and everything was fitting right except the repo gas cap .
|
07-25-2018, 03:09 PM | #5 |
Senior Member
Join Date: May 2010
Location: on the Littlefield
Posts: 6,140
|
Re: Windshield Blocked by Gascap...
I looked at a coupe with the problem ,compared it to mine and the reproduction header wasn't cut the same as original and put the hinge area too low,
|
07-26-2018, 07:00 AM | #6 |
Senior Member
Join Date: Nov 2011
Location: Greenwood SC
Posts: 293
|
Re: Windshield Blocked by Gascap...
Sponsored Links (Register now to hide all advertisements)
|
07-26-2018, 09:29 AM | #7 |
Senior Member
Join Date: Dec 2010
Location: FRESNO, CA
Posts: 12,560
|
Re: Windshield Blocked by Gascap...
On Minerva, my '30 Coupe, the window JUST cleared the cap & I could sit in the Pilots' Seat & gas her up!---Got lots of "LOOKS"---
Bill Attendant
__________________
"THE ASSISTANT GURU OF STUFF" |
07-26-2018, 11:31 AM | #8 |
Senior Member
Join Date: Apr 2011
Location: Endeavor, WI
Posts: 119
|
Re: Windshield Blocked by Gascap...
My cap has a cork gasket and not leather. I may try a more vintage style cap to see what happens.
I was going to get a tank filler screen but I can't tell if I should get the threaded one or the one with the tabs.
__________________
"I have not yet begun to defile myself." -Doc Holliday '31 Tudor, '69 F100, '66 Mustang, '11 Ford Flex |
07-26-2018, 01:34 PM | #9 |
Senior Member
Join Date: Dec 2017
Location: Guthrie, OK
Posts: 1,141
|
Re: Windshield Blocked by Gascap...
My gas cap is about 3/4" tall and the windshield clears just fine.
Early tanks used a threaded screen (flame arrester) but changed to tabs, then went back to threads, not sure of the exact timeline. Inside the neck of my '30 tank are two slots stamped near the opening for two of the tabs to twist into. Otherwise feel around for a thread groove. I got one that just drops in, but it rocks side to side. I might cut tabs on the top to hold it in place. |
Thread Tools | |
Display Modes | |
|
|
Sponsored Links (Register now to hide all advertisements) |
|