|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
07-25-2012, 10:37 AM | #1 |
Junior Member
Join Date: May 2010
Location: ipswich ma
Posts: 9
|
looking for a source to purchase taper locks
City:
ipswich
State:
ma
looking for a place to buy 3/4 ton ford taper locks that go in the axle shaft of a full floating rear.......the are the split pyramid looking piece that helps center the axle......i need 16........thanks for checkin....j/m
|
07-29-2012, 08:17 AM | #2 |
Senior Member
Join Date: May 2010
Posts: 191
|
Re: looking for a source to purchase taper locks
I have new NAPA brand cone and stud kits for your 3/4T truck. Includes 16 studs and 16 split cones, 1 box does 1 truck. $25.00 shipped in USPS flat rate box. New tapered cones only are $.75 each plus shipping in a padded envelope.Should cost $3.00 or less.Also have some of the larger size for 1 1/2Ton.
Keith Last edited by fordyford; 07-29-2012 at 10:59 AM. Reason: the NAPA boxes do not contain any nuts. |
Sponsored Links (Register now to hide all advertisements) |
|
07-29-2012, 10:01 AM | #3 |
Senior Member
Join Date: May 2010
Location: Manitoba Canada
Posts: 274
|
Re: looking for a source to purchase taper locks
Hi: I have axel taper locks (used) Asking $10.00 plus shipping for set of 16.
Stewart [email protected] |
07-30-2012, 01:38 PM | #4 |
Junior Member
Join Date: May 2010
Location: ipswich ma
Posts: 9
|
Re: looking for a source to purchase taper locks
Sponsored Links (Register now to hide all advertisements)
|
Thread Tools | |
Display Modes | |
|
|
Sponsored Links (Register now to hide all advertisements) |
|