Go Back   The Ford Barn > General Discussion > Early V8 (1932-53)

Sponsored Links (Register now to hide all advertisements)

 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
Old 01-27-2018, 11:31 PM   #1
Bulligen
Senior Member
 
Bulligen's Avatar
 
Join Date: Nov 2012
Location: Elgin Illinois
Posts: 735
Default Pulling flathead away from Trans

I am taking a flathead out of a 34 truck. Everything is disconnected, I have done this many times before , however this time is will not release. The steady rods are disconnected all the bolts are out ect. I have inserted screwdrivers between the block and trans and it has come away about a quarter inch. I can pry on them and the gap will open up another 1/4 of an inch or so but flexes right back. I am thinking the input shaft is rusted to the clutch disk and that is where the flex is coming from? Maybe I can get my torch in there through the inspection hole and warm things up. Anyone else have this happen?
Bulligen is offline   Reply With Quote
 

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 04:04 AM.