|
|||||||
| Sponsored Links (Register now to hide all advertisements) |
|
|
 |
|
Thread Tools | Display Modes |
|
|
09-11-2015, 11:25 AM
|
#1 |
|
Senior Member
Join Date: Dec 2014
Location: langley, wa.
Posts: 642
|
Carburetor confusion
Ordering jets for my zenith and looking at berths i see the cap jet which it says screws into the upper casting and it shows the idle jet described as also screwing into the upper casting. But I only see one threaded hole in the upper casting aside from the center bolt hole. So which is which?
|
|
|
|
09-11-2015, 11:40 AM
|
#2 |
|
Senior Member
Join Date: Jul 2010
Location: west coast Fla..
Posts: 311
|
Re: Carburetor confusion
Cap jet screws in the lower body next to the main jet.
|
|
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
|
09-11-2015, 11:47 AM
|
#3 |
|
BANNED
Join Date: May 2010
Location: Bucks County, PA
Posts: 11,454
|
Re: Carburetor confusion
Buy flow tested jets not the ones that most of the suppliers push
I get them from renners corner.. If Bert's flow tests them than that's fine also |
|
|
|
|
09-11-2015, 11:59 AM
|
#4 |
|
Senior Member
Join Date: Dec 2014
Location: langley, wa.
Posts: 642
|
Re: Carburetor confusion
Sponsored Links (Register now to hide all advertisements)
|
|
|
|
|
«
Previous Thread
|
Next Thread
»
Hybrid Mode
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
All times are GMT -5. The time now is 03:38 PM.