|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
05-23-2015, 01:44 PM | #22 |
Senior Member
Join Date: May 2010
Location: Windy City
Posts: 2,919
|
Re: shimming engine bearings
If you are doing this with the engine in place did you use a jack to exert upward pressure at each individual bearing when taking your plastigauge measurements? That crank can flex a few thou and give some strange readings if you do not forcibly push it up against the block babbitt while measuring from 'down under'.
|
Sponsored Links (Register now to hide all advertisements) |
|
Thread Tools | |
Display Modes | |
|
|
Sponsored Links (Register now to hide all advertisements) |
|