08-10-2018, 10:52 AM | #1 |
Senior Member
Join Date: Jul 2010
Location: United Kingdom
Posts: 1,441
|
Mochi carb ID
Not seen one of these before. Can anyone confirm that it's made in Argentinia and is for a model B. Has anyone stripped down and restored one of these? Any help appreciated.
|
08-10-2018, 10:58 AM | #2 |
Senior Member
Join Date: May 2010
Location: So Cal
Posts: 8,748
|
Re: Mochi carb ID
Wouldn't think it was for a B with the side fuel inlet.
|
Sponsored Links (Register now to hide all advertisements) |
|
08-10-2018, 11:34 AM | #3 |
Senior Member
Join Date: Jul 2010
Location: United Kingdom
Posts: 1,441
|
Re: Mochi carb ID
Yes, Good point. Here's some more pics.... idle passage goes up through body, venturi different .... Is it based on one of the cast iron Tillotsons? Any body know a source of gaskets for it?
|
08-10-2018, 12:29 PM | #4 |
Senior Member
Join Date: May 2010
Location: Alabama
Posts: 8,099
|
Re: Mochi carb ID
I've never heard of a cast iron Tillotson carburetor
|
08-10-2018, 12:32 PM | #5 |
Senior Member
Join Date: Feb 2012
Location: London England
Posts: 908
|
Re: Mochi carb ID
Something makes me think it might be Russian
|
08-10-2018, 01:06 PM | #6 |
Senior Member
Join Date: Jul 2010
Location: United Kingdom
Posts: 1,441
|
Re: Mochi carb ID
Sponsored Links (Register now to hide all advertisements)
|
08-10-2018, 01:55 PM | #7 |
Senior Member
Join Date: May 2010
Location: Alabama
Posts: 8,099
|
Re: Mochi carb ID
Mr. Buckley, thanks for your reply . I wasn't thinking that you were wrong about a cast iron Tillotson , I am always ready to learn if there actually was one .
|
08-10-2018, 03:35 PM | #8 |
Senior Member
Join Date: May 2010
Location: Glendale, AZ
Posts: 2,950
|
Re: Mochi carb ID
And this is a model B Mochi made by Industria Argentina
I made the gasket myself. Last edited by Joop; 08-10-2018 at 03:51 PM. |
08-10-2018, 03:51 PM | #9 |
Senior Member
Join Date: Jul 2010
Location: United Kingdom
Posts: 1,441
|
Re: Mochi carb ID
Thanks Joop, looks similar to the Mochi 3 that started this thread, other than end entry for fuel inlet
|
|
|
Sponsored Links (Register now to hide all advertisements) |
|