|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
01-25-2016, 07:22 PM | #1 |
Senior Member
Join Date: Nov 2014
Location: Stuart Florida
Posts: 108
|
Correct Tie rod Length for 28 Tudor
Started working on the front end of my 28 and noticed that the tie rod has a slight bend in it. I am thinking that replacing the tie rod is in order. I measured the tie rod and it is 42 7/8" long. The tie rod ends were adjusted almost all of the way down - that is, I doubt I could have turned them in another inch, but the new tie rods are all about 44". Any advice out there?
|
01-25-2016, 07:42 PM | #2 |
BANNED
Join Date: May 2010
Location: Gothenburg Nebraska Just off I-80
Posts: 4,893
|
Re: Correct Tie rod Length for 28 Tudor
This was discussed on the old fordbarn. As pointed out in the Service Bulletins the steering arms were changed and with this change the tie rod length was changed. These are not real hard to find. I may still have one out at the farm, but will not be out there again til next week. Probably best to call Berts or someone else may have one also. Rod
__________________
Do the RIGHT thing - Support the H.A.M.B. Alliance!!!! |
Sponsored Links (Register now to hide all advertisements) |
|
01-25-2016, 07:49 PM | #3 |
Senior Member
Join Date: Nov 2014
Location: Stuart Florida
Posts: 108
|
Re: Correct Tie rod Length for 28 Tudor
Thanks. Will do!
|
01-25-2016, 08:57 PM | #4 |
Senior Member
Join Date: May 2010
Location: Mpls, MN
Posts: 27,582
|
Re: Correct Tie rod Length for 28 Tudor
Sponsored Links (Register now to hide all advertisements)
|
|
|
Sponsored Links (Register now to hide all advertisements) |
|