|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
09-08-2019, 09:03 AM | #1 |
Member
Join Date: Aug 2010
Location: australia
Posts: 58
|
34 front engine mount /water outlet
Are there any suppliers of new castings for the front enginemount / water outlet for 34 engine mine have both corroded away , thanks in advance
|
09-08-2019, 09:28 AM | #2 |
Senior Member
Join Date: May 2010
Location: Southern France
Posts: 5,306
|
Re: 34 front engine mount /water outlet
Not reproduced to my knowledge.The Ford Store in San Dimas,CA might have a nice original pair available.Maybe a member here also.
|
Sponsored Links (Register now to hide all advertisements) |
|
09-08-2019, 09:52 AM | #3 |
Senior Member
Join Date: May 2010
Posts: 642
|
Re: 34 front engine mount /water outlet
I have a pair but they are not marked ! I thought they were 35 when I bought them but they were too Narrow when mounted on my engine so maybe ethey are 34/34, You are wlecome to have them for the 35 dollars I have in them plus the S&H cost.. They are useable but have some rust at the outlets. kerk
|
09-08-2019, 10:14 AM | #4 |
BANNED
Join Date: May 2010
Posts: 3,019
|
Re: 34 front engine mount /water outlet
Phil,
I have some....they are originals. I machine off the rotted water snout and and counter bore into the now solid iron. I renew the proper length snout with an iron sleeve that is step turned and pressed into the orig casting. In addition to the press fit on the sleeve I use JB long setting epoxy. No issues, some Barners are using them. I would certainly welcome any comment either way. Charlie ny [email protected] |
09-08-2019, 01:49 PM | #5 |
Senior Member
Join Date: May 2010
Location: so cal, placerville, vegas
Posts: 1,394
|
Re: 34 front engine mount /water outlet
Charlie's repair is GOOD.
I also have a pair that are available. Some rust-out on ends, but still usable. They have the part # cast on. |
09-09-2019, 07:51 AM | #6 | |
Member
Join Date: Aug 2010
Location: australia
Posts: 58
|
Re: 34 front engine mount /water outlet
Sponsored Links (Register now to hide all advertisements)
Quote:
|
|
09-09-2019, 10:36 AM | #7 |
Senior Member
Join Date: May 2010
Location: southeastern Michigan
Posts: 10,101
|
Re: 34 front engine mount /water outlet
I recommend one additional step after the repairs have been completed, namely powder coating inside and out. If your powder coating source doesn't have the Ford engine green color you can always add that over the powder coating with a rattle can.
|
|
|
Sponsored Links (Register now to hide all advertisements) |
|