|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
11-14-2021, 04:03 AM | #1 |
Junior Member
Join Date: Dec 2013
Posts: 10
|
Replacement panel sections
Does anyone make the rear body section that the bumper brackets go through on 1938 to 1940 Ford Sedans, photo is section I am after.
|
11-14-2021, 07:48 AM | #2 |
Senior Member
Join Date: May 2010
Location: Southern France
Posts: 5,305
|
Re: Replacement panel sections
Howell's Sheet Metal in TX but beware -not good reviews here.When I looked it doesn't show the slots for the bumper brackets.
|
Sponsored Links (Register now to hide all advertisements) |
|
11-14-2021, 08:30 AM | #3 |
Senior Member
Join Date: May 2010
Location: Wisconsin, USA
Posts: 8,995
|
Re: Replacement panel sections
No one makes those repair pieces that I am aware of. That area, for those that may not recall, is unlike the coupes. Sedans have the bumper arm openings in the quarter panel.
__________________
"I can explain it for you. However, I can't understand it for you". |
11-14-2021, 06:49 PM | #4 |
Senior Member
Join Date: May 2010
Posts: 2,484
|
Re: Replacement panel sections
I have two '39 sdn bodies about to be scrapped. Newc in Oregon
|
11-17-2021, 05:10 AM | #5 |
Junior Member
Join Date: Dec 2013
Posts: 10
|
Re: Replacement panel sections
Thanks everyone for comments, I have 3 sets to make , it toke me about 40 hours to fabricate the left side, a lot of swearing and frustration, still working on right side.
|
11-17-2021, 09:37 AM | #6 |
Senior Member
Join Date: Dec 2014
Location: Columbus, IN
Posts: 1,406
|
Re: Replacement panel sections
Sponsored Links (Register now to hide all advertisements)
|
|
|
Sponsored Links (Register now to hide all advertisements) |
|