Go Back   The Ford Barn > General Discussion > Model A (1928-31)

Sponsored Links (Register now to hide all advertisements)

Reply
 
Thread Tools Display Modes
Old 01-21-2019, 02:41 PM   #1
Turbo26T
Junior Member
 
Join Date: Feb 2013
Posts: 25
Default '30-'31 Coupe inside door to B pillar gap

'30-'31 Coupe (45B) Inside of car ,facing door rear edge & B pillar..Whats the gap between the door shell rear edge to the B pillar... Interested in @top ,@ lock area,and bottom...Logic says it should be even , but would appreciate some real world measurements...
If someone has a car with good fitting doors could measure the inside gap for me ,I would greatly appreciate it
I'm trying to verify fitment before I fasten anything permanently..
Thanks ,
Stan

Last edited by Turbo26T; 01-23-2019 at 04:41 PM.
Turbo26T is offline   Reply With Quote
Old 01-21-2019, 03:33 PM   #2
Bob C
Senior Member
 
Join Date: May 2010
Location: So Cal
Posts: 5,976
Default Re: '30-'31 Coupe inside door to B pillar gap

This might help a little. http://www.fordgarage.com/pages/bodymeasurements.htm


Bob
Bob C is offline   Reply With Quote
Sponsored Links (Register now to hide all advertisements)
Old 01-21-2019, 05:11 PM   #3
Turbo26T
Junior Member
 
Join Date: Feb 2013
Posts: 25
Default Re: '30-'31 Coupe inside door to B pillar gap

Bob: Thanks for the reply...I'm aware of those measurements and they are not what I need to verify some fitment issues..
I have searched the archives and have read /seen the normally referred to threads
Stan

Last edited by Turbo26T; 01-21-2019 at 05:24 PM.
Turbo26T is offline   Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 02:51 AM.