The Ford Barn

vern hodgson · 09-11-2015, 11:25 AM

Ordering jets for my zenith and looking at berths i see the cap jet which it says screws into the upper casting and it shows the idle jet described as also screwing into the upper casting. But I only see one threaded hole in the upper casting aside from the center bolt hole. So which is which?

JD 1931 · 09-11-2015, 11:40 AM

Cap jet screws in the lower body next to the main jet.

Mitch//pa · 09-11-2015, 11:47 AM

Buy flow tested jets not the ones that most of the suppliers push
I get them from renners corner..
If Bert's flow tests them than that's fine also

vern hodgson · 09-11-2015, 11:59 AM

Ok, thanks

09-11-2015, 11:25 AM	#1
vern hodgson Senior Member Join Date: Dec 2014 Location: langley, wa. Posts: 422	Carburetor confusion Ordering jets for my zenith and looking at berths i see the cap jet which it says screws into the upper casting and it shows the idle jet described as also screwing into the upper casting. But I only see one threaded hole in the upper casting aside from the center bolt hole. So which is which?

09-11-2015, 11:40 AM	#2
JD 1931 Senior Member Join Date: Jul 2010 Location: west coast Fla.. Posts: 230	Re: Carburetor confusion Cap jet screws in the lower body next to the main jet.

09-11-2015, 11:47 AM	#3
Mitch//pa BANNED Join Date: May 2010 Location: Bucks County, PA Posts: 11,454	Re: Carburetor confusion Buy flow tested jets not the ones that most of the suppliers push I get them from renners corner.. If Bert's flow tests them than that's fine also

09-11-2015, 11:59 AM	#4
vern hodgson Senior Member Join Date: Dec 2014 Location: langley, wa. Posts: 422	Re: Carburetor confusion Ok, thanks

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode