|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
04-18-2018, 05:40 PM | #1 |
Senior Member
Join Date: Feb 2011
Location: Lincoln, Nebraska
Posts: 1,907
|
Hose clamp orientation
Some time ago someone went into detail here as to the correct orientation of the radiator hose clamps. I know (think) that I printed it out for later use (it's now later) but can not find it. I've searched the forum but no luck. If that could be posted again I would appreciate it.
__________________
Dave / Lincoln Nebraska |
04-18-2018, 05:59 PM | #2 |
Senior Member
Join Date: Feb 2014
Location: Lake Mills, WI
Posts: 251
|
Re: Hose clamp orientation
The JS&RG book says, 'Both radiator inlet upper hose clamps had the screw on the top side of the hose with the head towards the drivers side. On the radiator outlet hose nearest the radiator, the clamps had the screw on the drivers side with the head facing upwards. On the outlet hose at the cylinder water inlet casting, the clamps had the screw on the top of the hose with the head facing the drivers side.
__________________
Always one bad decision away from a good time. |
Sponsored Links (Register now to hide all advertisements) |
|
04-18-2018, 09:40 PM | #3 |
Senior Member
Join Date: May 2010
Posts: 332
|
Re: Hose clamp orientation
Is there a correct way to line up the red stripe along with the clamps?
|
04-18-2018, 11:05 PM | #4 |
Senior Member
Join Date: Aug 2010
Location: Port Orchard, WA
Posts: 1,498
|
Re: Hose clamp orientation
RG&JS page 3-4
Revised 2011 "Radiator hoses were predominantly black with a red longitudinal stripe which was installed with the red stripe facing upward ........."
__________________
1931 160B & 1931 68B If you don't have time to do it right the 1st time, how do you have time to do it the 2nd time? |
04-19-2018, 07:30 AM | #5 |
Senior Member
Join Date: May 2010
Posts: 332
|
Re: Hose clamp orientation
Thanks , I read that area but missed the part about the red facing up . Norm
|
04-19-2018, 12:22 PM | #6 |
Senior Member
Join Date: Feb 2011
Location: Lincoln, Nebraska
Posts: 1,907
|
Re: Hose clamp orientation
Sponsored Links (Register now to hide all advertisements)
__________________
Dave / Lincoln Nebraska |
|
|
Sponsored Links (Register now to hide all advertisements) |
|