|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
11-11-2019, 08:12 AM | #41 | |
Senior Member
Join Date: May 2010
Location: NJ
Posts: 6,177
|
Re: 32 axle bent twist ?
Quote:
I just shipped a '32 axle to Greg and was dumbfounded when it cost $50 to ship it to his business. Round trip would have been $100. Outrageous. Last edited by Tim Ayers; 11-11-2019 at 08:25 AM. |
|
11-11-2019, 04:34 PM | #42 |
Senior Member
Join Date: May 2014
Location: Ontario
Posts: 207
|
Re: 32 axle bent twist ?
Ok, Thanks again everyone for the tremendous help Looks like I got the wishbone were it should be , and axle will be shipped out
Now I’m getting a little ahead of myself, but I don’t see a recommendation for torque on the perch pin castle nut what is everyone setting them at ? |
Sponsored Links (Register now to hide all advertisements) |
|
11-11-2019, 04:41 PM | #43 |
Senior Member
Join Date: May 2010
Location: Solihull, England.
Posts: 8,744
|
Re: 32 axle bent twist ?
As tight as you can, bearing in mind you want to end up with a split pin hole lining up. 100lbs ft plus. (I don't use a figure, just v. tight with a 30" bar.)
|
11-11-2019, 06:45 PM | #44 |
Senior Member
Join Date: May 2010
Location: Capital of Corruption , NY
Posts: 811
|
Re: 32 axle bent twist ?
If you have a gap between the wishbone mount to the axle, it can be shimmed.
|
|
|
Sponsored Links (Register now to hide all advertisements) |
|