|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
01-01-2020, 07:50 PM | #1 |
Member
Join Date: Dec 2012
Location: Lawrence, KS
Posts: 35
|
Pulling engine and transmission...can I put both in cradle?
I'm needing to pull the engine and transmission from my '30 Cabriolet project so that I can replace the existing front cross member with the correct one. I will have it stripped down to the frame, so getting the engine and transmission out together shouldn't be too bad. I'd like to temporarily store the engine and transmission together in a wooden cradle that I'll build and have on the concrete floor out of the way while I work on drilling out the old rivets and riveting in the new (old but correct) cross member. Any reason that I couldn't (or shouldn't) use the wooden cradle plans posted on here a couple of years ago, and add some additional supports for the transmission? Thanks for your thoughts and advice, as I'm a newbie to Model A's!
Last edited by CabrioletDon; 01-01-2020 at 07:51 PM. Reason: spelling |
01-02-2020, 01:10 AM | #2 |
Senior Member
Join Date: May 2010
Location: Oregon
Posts: 5,959
|
Re: Pulling engine and transmission...can I put both in cradle?
As long as it is supported what could go wrong?
Last edited by J Franklin; 01-03-2020 at 04:11 PM. |
Sponsored Links (Register now to hide all advertisements) |
|
01-03-2020, 02:44 AM | #3 |
Senior Member
Join Date: Jul 2011
Location: Redondo Beach, CA
Posts: 5,848
|
Re: Pulling engine and transmission...can I put both in cradle?
Welcome to Model As and the Barn.
I built several wooden cradles. I have used them to transport my engine to and from the machine shop and the hold my rebuilt engine before I was ready to reinstall. I even started the engine while on the cradle before installation to "check it out". That same cradle is now holding a friends rebuilt engine. I have one for my spare engine also (in back ground). I never tried it with a transmission but if you support the back of the trans the wooden cradle is certainly strong enough to hold the weight. |
01-03-2020, 03:36 AM | #4 |
Senior Member
Join Date: Nov 2011
Location: Sonoma, CA.
Posts: 1,496
|
Re: Pulling engine and transmission...can I put both in cradle?
The transmission will hang on the back, no problem. You don’t need to support it.
The engine weighs enough to keep it on the cradle with out support. I do it all the time. |
01-03-2020, 11:23 AM | #5 |
Senior Member
Join Date: May 2010
Location: Hangtown, CA
Posts: 556
|
Re: Pulling engine and transmission...can I put both in cradle?
It works just fine, no problem.
|
01-03-2020, 11:30 AM | #6 |
Senior Member
Join Date: Jul 2011
Location: Redondo Beach, CA
Posts: 5,848
|
Re: Pulling engine and transmission...can I put both in cradle?
|
|
|
Sponsored Links (Register now to hide all advertisements) |
|