Go Back   The Ford Barn > To The Editors > Questions & Suggestions

Sponsored Links (Register now to hide all advertisements)

Reply
 
Thread Tools Display Modes
Old 04-22-2013, 09:27 PM   #1
Nickster
Junior Member
 
Nickster's Avatar
 
Join Date: Jul 2012
Location: Paso Robles, California
Posts: 12
Default Cooling

I have a '46 Ford with a 350 chevy, new 4" radiator, pulley driven fan that I'd like to convert to an electric fan. Space between the radiator and a long shaft water pump shaft is 2" (very limited), I'd like to put in a 16" pusher fan. Do I retain the pulley driven fan? Do I add a shroud? A personal experience with this issue is appreciated. And any advice is welcomed.
Nickster is offline   Reply With Quote
Old 04-23-2013, 09:49 PM   #2
parklane
Senior Member
 
parklane's Avatar
 
Join Date: May 2010
Location: St.Thomas, ON Canada
Posts: 589
Default Re: Cooling

I would ask this on the early V8 general discussion section, but don't mention about the sbc engine. They are more into the original stuff. You could also ask this on the HAMB. JMHO, is the first thing to try is a proper shroud.
__________________
If brains were wire, some couldn't short circuit a firefly
parklane is offline   Reply With Quote
Sponsored Links (Register now to hide all advertisements)
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 12:18 PM.