|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
05-15-2015, 08:12 PM | #1 |
Senior Member
Join Date: May 2010
Location: Lakeville, MN
Posts: 5,162
|
Pickup taillight mounting block
I searched the archives for the dimensions of the taillight mounting block used to mount the taillight bracket to a pickup bed, but couldn't find anything. The block looks very simple to make if I had the dimensions. If anyone has a taillight mounting block that could post the dimensions, I would appreciate it.
Rusty Nelson |
05-15-2015, 08:55 PM | #2 |
BANNED
Join Date: Feb 2015
Location: East Central Iowa
Posts: 1,275
|
Re: Pickup taillight mounting block
I'm going to mount my taillights on the rear fenders of my 1930 CCPU like my old 30 Coupe.
You can always measure the hole spacing on the wood rails. Larry Jenkins |
Sponsored Links (Register now to hide all advertisements) |
|
05-16-2015, 09:07 AM | #3 |
Senior Member
Join Date: Mar 2014
Location: Midland Park,N.J.
Posts: 1,108
|
Re: Pickup taillight mounting block
I just measured the block on my29 ccpu it's as follows,3'' long,2''high,1 1/2"wide,I had to shave the block slightly so the taillight was level.
|
05-16-2015, 09:30 AM | #4 |
Senior Member
Join Date: May 2010
Location: Lakeville, MN
Posts: 5,162
|
Re: Pickup taillight mounting block
Sponsored Links (Register now to hide all advertisements)
Rusty Nelson |
|
|
Sponsored Links (Register now to hide all advertisements) |
|