Go Back   The Ford Barn > General Discussion > Early V8 (1932-53)

Sponsored Links (Register now to hide all advertisements)

Reply
 
Thread Tools Display Modes
Old 01-10-2018, 09:28 AM   #1
wgreeley
Junior Member
 
wgreeley's Avatar
 
Join Date: Aug 2017
Location: Marblehead, MA
Posts: 13
Default 36 Ford radio head repair

I wonder if someone has taken apart a 36 Philco FT-9 control head. I need to remove the switch for repair, but the dial gears are in the way. Does anyone know how to remove the dial gears. The right hand gear is captive to the center dial gear which doesn't want to come off. Both gears rotate freely.
wgreeley is offline   Reply With Quote
Old 01-10-2018, 04:21 PM   #2
wamnram
Senior Member
 
wamnram's Avatar
 
Join Date: May 2010
Location: San Tan Valley, Arizona
Posts: 210
Default Re: 36 Ford radio head repair

There is a small wire clip behind the gears that holds them in. maybe someone else on here will have a picture of it.
__________________
Wayne
wamnram is offline   Reply With Quote
Sponsored Links (Register now to hide all advertisements)
Old 01-10-2018, 08:09 PM   #3
Brendan
Senior Member
 
Brendan's Avatar
 
Join Date: May 2010
Location: At my kitchen table in Santa Rosa, Ca
Posts: 2,903
Default Re: 36 Ford radio head repair

looks like a clock!
__________________
If it would have been a snake it would have bit ya!

i can't spell my way out of a paper bag!
Brendan is offline   Reply With Quote
Old 01-13-2018, 08:40 PM   #4
wgreeley
Junior Member
 
wgreeley's Avatar
 
Join Date: Aug 2017
Location: Marblehead, MA
Posts: 13
Default Re: 36 Ford radio head repair

Thanks Wayne. That was it. A little DeoxIT contact cleaner and the switch was fine.
wgreeley is offline   Reply With Quote
Old 09-23-2023, 09:37 AM   #5
jgclark1957
Member
 
jgclark1957's Avatar
 
Join Date: Sep 2016
Location: Northford, CT
Posts: 82
Default Re: 36 Ford radio head repair

Sponsored Links (Register now to hide all advertisements)
Hello;
Is it too late to get further information about this thread?
I am also attempting to remove the switch from my Ford Philco FT9 Radio Head.
I am encountering the same issue that "wgreeley" ran into. The right gear is retained by the center gear and I can't seem to remove the center gear. There is a very small spring that is connected between the 2 gear shafts and clips to the hole in the center gear. I have disconnected that spring but I still can't figure out how the center gear is removed.
Any help would be greatly appreciated.
Thanks in advance.
Jim
Attached Images
File Type: jpg FT9-Radio-Head.jpg (54.2 KB, 14 views)
jgclark1957 is offline   Reply With Quote
Reply


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 06:10 AM.