|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
05-24-2017, 05:52 AM | #1 |
Senior Member
Join Date: Jul 2014
Location: NW Pa./Sc.
Posts: 252
|
31 Victoria patch panels
I hope to be looking at a 31 Victoria in a week or so. It has the usual bubbling of the paint on the bottom of the cowl panels. I've been to a number of vendor's web sites, but I'm a little confused regarding the correct metal cowl patch panels for a Victoria. Also I would appreciate any input on quality. Any thoughts would be greatly appreciated. Thanks, Smitty
|
05-24-2017, 06:08 AM | #2 |
Senior Member
Join Date: Jun 2015
Location: Signal Mtn, TN (SE TN)
Posts: 2,370
|
Re: 31 Victoria patch panels
Most vendors carry the correct contoured patches. They have to be shortened to fit a slant
If you are going to install you should be able to modify |
Sponsored Links (Register now to hide all advertisements) |
|
05-26-2017, 01:09 AM | #3 |
Senior Member
|
Re: 31 Victoria patch panels
Stipe manufacturing had panels that were great to use (had to be cut for use with the Victoria as mentioned) but I don't see them on the site now. I have an extra set.
__________________
What's right about America is that although we have a mess of problems, we have great capacity - intellect and resources - to do some thing about them. - Henry Ford II |
05-26-2017, 10:55 AM | #4 |
Senior Member
Join Date: May 2010
Location: Long Island, NY
Posts: 3,464
|
Re: 31 Victoria patch panels
The cowl patch panels used on my 190A were custom made to fit. Although the patch panels were made to fit the whole width of the cowl, only a small segment of the panels was used to keep as much of the original cowl metal as possible.
__________________
Bob Bidonde |
05-26-2017, 12:13 PM | #5 |
Senior Member
Join Date: May 2010
Location: Mpls, MN
Posts: 27,582
|
Re: 31 Victoria patch panels
Sponsored Links (Register now to hide all advertisements)
|
|
|
Sponsored Links (Register now to hide all advertisements) |
|