Go Back   The Ford Barn > General Discussion > Model T (1909-1927)

Sponsored Links (Register now to hide all advertisements)

Reply
 
Thread Tools Display Modes
Old 04-25-2020, 07:58 PM   #1
burner31
Senior Member
 
burner31's Avatar
 
Join Date: Dec 2014
Location: Shawnee, Ok
Posts: 2,830
Default changing brake cam support

Does the brake shaft have to be disconnected from the band and pulled completely out in order to change the brake cam support.
Same question for the clutch and reverse.
Attached Images
File Type: jpg 474337s.jpg (3.3 KB, 21 views)
__________________
Keith
Shawnee OK
'31 SW 160-B
burner31 is online now   Reply With Quote
Old 04-25-2020, 09:17 PM   #2
redmodelt
Senior Member
 
redmodelt's Avatar
 
Join Date: May 2010
Location: Portland OR
Posts: 5,003
Default Re: changing brake cam support

You have to pull the hogs head to replace the low(clutch) cam. This part;
https://www.modeltford.com/item/3428.aspx it's riveted to the shaft which needs to be supported when the rivet is driven out. Also, the shafts go thru them so yes the pedals need to be removed. You might be able to get to the head of the bolt thru the door for the brake cam, but don't think you could for reverse. Don't loose the bolts, they are special thin headed ones.
__________________
I know the voices aren't real but damn they have some good ideas!
redmodelt is offline   Reply With Quote
Sponsored Links (Register now to hide all advertisements)
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 01:16 PM.