|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
08-16-2018, 12:20 AM | #1 |
Senior Member
Join Date: Sep 2011
Location: Christchurch New Zealand
Posts: 1,610
|
!939 Flathead 221 Rear Seal
Short senario reassembly stalled for want of a rear seal , not supplied in Best Gasket O/haul kit. Had a seal but too small dia is 8mm. Rope seal needs to be 9.5mm.
My question: is the rear rope seal 91A-6347 of this dimension? As the seal as fitted was this small dia of 8mm and was only touching in a couple of places, hence the rear oil leak. Van Pelt has these rear seal kits so maybe best to get from him provided it is 9.5mm section. Appreciate advice. Phil NZ |
08-16-2018, 12:39 AM | #2 |
Senior Member
Join Date: Jun 2010
Location: Oxford New Zealand
Posts: 177
|
Re: !939 Flathead 221 Rear Seal
Hi Phil.Have just got my 81A engine running in the '38 and used a graphite seal and doesn't leak at all over quite a few miles.It is a square section rope of 9mm and impregnated with graphite.Comes with a cut off knife and guage.Best one yet for me.Cheers.
|
Sponsored Links (Register now to hide all advertisements) |
|
08-16-2018, 12:46 AM | #3 |
Senior Member
Join Date: May 2010
Location: Masterton, New Zealand
Posts: 3,828
|
Re: !939 Flathead 221 Rear Seal
Phil, pm sent, please reply ASAP- I have exactly what you need. Need your address.
__________________
Unfortunately, two half wits don't make a whole wit! |
08-16-2018, 01:00 AM | #4 | |
Senior Member
Join Date: Sep 2011
Location: Christchurch New Zealand
Posts: 1,610
|
Re: !939 Flathead 221 Rear Seal
Quote:
Phil NZ |
|
08-16-2018, 01:17 AM | #5 |
Senior Member
Join Date: Sep 2011
Location: Christchurch New Zealand
Posts: 1,610
|
Re: !939 Flathead 221 Rear Seal
Sponsored Links (Register now to hide all advertisements)
Pays to check before pushing that BUY NOW!! Phil NZ |
|
|
Sponsored Links (Register now to hide all advertisements) |
|