|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
02-09-2021, 05:54 PM | #1 |
Senior Member
Join Date: May 2010
Location: 215 E. 6th Street Northport, Michigan 49670
Posts: 941
|
Wood header question 30'
What type fasteners/screws/bolts are used to hold the wood header to the metal angle section over the windshield on a 1930 Sport Coupe???
__________________
Bob from Northport Northport, Michigan Last edited by Bob from Northport; 01-24-2022 at 09:39 PM. |
02-10-2021, 09:00 PM | #2 |
Senior Member
Join Date: May 2010
Location: 215 E. 6th Street Northport, Michigan 49670
Posts: 941
|
Re: Wood header question 30'
bmp
__________________
Bob from Northport Northport, Michigan |
Sponsored Links (Register now to hide all advertisements) |
|
02-11-2021, 09:27 PM | #3 |
Senior Member
Join Date: May 2010
Location: 215 E. 6th Street Northport, Michigan 49670
Posts: 941
|
Re: Wood header question 30'
I located the answer to my question for those that wish to know. The header is held by 5/16x18x1 3/4" Stove bolt flat head screws.
__________________
Bob from Northport Northport, Michigan Last edited by Bob from Northport; 01-24-2022 at 09:39 PM. |
02-12-2021, 12:01 PM | #4 |
Senior Member
Join Date: Dec 2011
Location: SW Idaho
Posts: 970
|
Re: Wood header question 30'
And t nuts for the front side.
|
02-12-2021, 12:11 PM | #5 |
Senior Member
Join Date: May 2010
Location: 215 E. 6th Street Northport, Michigan 49670
Posts: 941
|
Re: Wood header question 30'
Sponsored Links (Register now to hide all advertisements)
__________________
Bob from Northport Northport, Michigan |
|
|
Sponsored Links (Register now to hide all advertisements) |
|