Go Back   The Ford Barn > General Discussion > Model A (1928-31)

Sponsored Links (Register now to hide all advertisements)

 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
Old 03-21-2016, 11:39 AM   #1
Terry, NJ
Senior Member
 
Terry, NJ's Avatar
 
Join Date: May 2010
Location: Bucks Co, Pa
Posts: 3,380
Default Body to frame! Anyone ever have this?

No pics this time, you'll have to visualize. I'm trying to bolt my newly painted 4 dr body onto the frame and something keeps holding it up about 1/8 " over. It just won't lay down flat on the frame. The 1/8" welting is full frame length. With clearances cut around bolt heads.It sits down in the front, it's only the in the rearThe only things that seems to be holding the sills up are the two rear bumper brackets. Clamping hard and pulling it down with the frame bolts on the rest of the frame might solve one problem, but cause more (door fit for one). So, Should I shim the body sills and just pull it down, or what.
Additionally, I want to warn you all about "Classic Woods" body sills. It's a small thing. The three holes on each side for the front seat brackets (slider brackets) are drilled in too wide a pattern They are off about 1/2 inch, it makes the wooden seat frame not fit. Snyders lists about 3 4dr styles of front seats. do any of these have a different hole spacing where the slider brackets bolt to the frame? These bolts would be 5/16" X approximately 2 1/4 long 3 per side, 6 altogether
Terry

Last edited by Terry, NJ; 03-21-2016 at 03:03 PM.
Terry, NJ is offline   Reply With Quote
 

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 09:16 PM.