Go Back   The Ford Barn > The Swap Meet > Wanted > Model-A

Sponsored Links (Register now to hide all advertisements)

Thread Tools Display Modes
Old 12-15-2018, 11:53 AM   #1
Steve Plucker
Senior Member
Steve Plucker's Avatar
Join Date: May 2010
Location: Walla Walla, Washington USA
Posts: 5,632
Default Spindle Arms

City: Prescott
State: WA

Spindle Arms...3rd Style

On page 4-2 Revised 2011 of the MARC/MAFCA RESTORATION GUIDELINES and JUDGING STANDARDSand page 283 of the Ford Service Bulletins, tell us that there was a change in the dimentions of the Spindle Arms...both right and left.

The change was the repositioning of the Tie Rod Arms only.

I have at least 15 or so of the double ball arms at the 13/16" and about the same for the single ball arm and am in need of the 3rd type as explaned in the Standards but have none. I would of thought for sure I would of.

Does anyone have a set of the 3rd type...BEFORE the change in the Tie Rod Arms themselves and at the correct measurements on 1-1/8" inch?

I have one of the two ball type that could be in the ball park but is way more than the 1-1/8" that the standards and bulletins say yet it has the correct part number on the casting. More than likely this one is bent but it sure does not look it.

This is also in the classifieds...


Please email me at pif@bmi.net


Walla Walla (WA) Sweet A's since 1993

MARC/MAFCA member since 1978

Ford Model AA Truck Club since 1998

(LIONEL/MTH Toy Train Collector, Orange Crush Soda Collector, Steel Beer Can Collector, Old Gas Pump Collector)
Steve Plucker is offline   Reply With Quote
Sponsored Links (Register now to hide all advertisements)

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Sponsored Links (Register now to hide all advertisements)

All times are GMT -5. The time now is 02:34 AM.