|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
07-12-2015, 08:11 AM | #1 |
Member
Join Date: May 2010
Posts: 54
|
Another brake question
I am going to replace the worn adjustment wedges on the rear and the brake adjusting shafts are showing some wear - some rounding, can I redress these on a grinder or file them to the original angle some how or not worth trying or just purchase new ones ? Thanks , John Spragg Australia.
|
07-12-2015, 09:03 AM | #2 |
Senior Member
Join Date: May 2010
Location: Mpls, MN
Posts: 27,582
|
Re: Another brake question
I think you are asking about the angled ends on the shafts that engage the slots of the adjustment cones. I've never seen them worn enough to worry about, but just make sure you use equal length shafts for each of the 4 drums. In other words, each pair for one wheel should match, but could be a little different from another pair.
|
Sponsored Links (Register now to hide all advertisements) |
|
07-12-2015, 09:36 AM | #3 |
Senior Member
Join Date: Apr 2011
Location: Davenport, Iowa
Posts: 2,111
|
Re: Another brake question
Sponsored Links (Register now to hide all advertisements)
Marshall |
|
|
Sponsored Links (Register now to hide all advertisements) |
|