Small felt washer

[oldbird55]

Does anybody know how to install the small felt washer on the brake rod inside the kingpin.

[Mitch//pa]

Loosen the backing plate a tad for it to slip in between....

[Tom Wesenberg]

As Mitch said, you need to have the push rod out, then slip the felt in the space between the backing plate and bottom of the axle. It doesn't go inside the kingpin, even though I read it described that way once.

[redmodelt]

I put the felt on the backing plate then push the rod just through just enough to hold in place, grease the felt first. Then I tip the pack plate, bottom first, in to place and shove the rod home. Bolt the backing plate to spindle.

[Barber31]

Originally Posted by Tom Wesenberg

It doesn't go inside the kingpin, even though I read it described that way once.

I recall reading it that way also. Although I didn't heed this installation method it was described as being fitted inside the kingpin to stop any debri from going up into the kingpin. I want to say it was the red book that described it this way.

[ian Simpson]

Sponsored Links (Register now to hide all advertisements)

I did it like Tom said in post #3, above.