|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
12-11-2016, 01:10 AM | #1 |
Junior Member
Join Date: May 2016
Posts: 4
|
Remove V8 oil pan on a '37 Ford Sedan
Is it possible to remove a V8 oil pan from a '37 Ford Sedan while the motor is in the car? I have all the pan and appropriate transmission bolts out, the the starter is removed as is the wishbone. The pan is loose and I've jacked the motor up as far as it will go (breather hits the firewall) and I can't clear the front crossmember and the crank counterweight to get it out. Are there any tricks? I hate the thought of pulling the motor to change a leaky front seal. Thanks.
|
12-11-2016, 01:31 AM | #2 |
Senior Member
Join Date: May 2010
Location: Masterton, New Zealand
Posts: 3,834
|
Re: Remove V8 oil pan on a '37 Ford Sedan
Rotate the crankshaft.
__________________
Unfortunately, two half wits don't make a whole wit! |
Sponsored Links (Register now to hide all advertisements) |
|
12-11-2016, 02:18 AM | #3 |
Senior Member
Join Date: May 2010
Location: Damascus Oregon
Posts: 160
|
Re: Remove V8 oil pan on a '37 Ford Sedan
I did it on my 37 in 1964.
Jack up the car by the frame so that the front suspension hangs down. Jack up the engine. It will come off by dropping and rotating it. |
12-11-2016, 01:51 PM | #4 |
Senior Member
Join Date: Aug 2010
Location: New Zealand
Posts: 1,111
|
Re: Remove V8 oil pan on a '37 Ford Sedan
I did remove the pan in our 37 coupe back in the 80s. It was a mission but came out. Don't think it matters but our motor was a 99a.
|
12-11-2016, 08:08 PM | #5 |
Senior Member
Join Date: May 2010
Location: At my kitchen table in Santa Rosa, Ca
Posts: 2,903
|
Re: Remove V8 oil pan on a '37 Ford Sedan
Sponsored Links (Register now to hide all advertisements)
__________________
If it would have been a snake it would have bit ya! i can't spell my way out of a paper bag! |
|
|
Sponsored Links (Register now to hide all advertisements) |
|