The Ford Barn

Turbo26T · 01-21-2019, 02:41 PM

'30-'31 Coupe (45B) Inside of car ,facing door rear edge & B pillar..Whats the gap between the door shell rear edge to the B pillar... Interested in @top ,@ lock area,and bottom...Logic says it should be even , but would appreciate some real world measurements...
If someone has a car with good fitting doors could measure the inside gap for me ,I would greatly appreciate it
I'm trying to verify fitment before I fasten anything permanently..
Thanks ,
Stan

Bob C · 01-21-2019, 03:33 PM

This might help a little. http://www.fordgarage.com/pages/bodymeasurements.htm

Bob

Turbo26T · 01-21-2019, 05:11 PM

Sponsored Links (Register now to hide all advertisements)

Bob: Thanks for the reply...I'm aware of those measurements and they are not what I need to verify some fitment issues..
I have searched the archives and have read /seen the normally referred to threads
Stan

01-21-2019, 02:41 PM	#1
Turbo26T Member Join Date: Feb 2013 Posts: 57	'30-'31 Coupe inside door to B pillar gap '30-'31 Coupe (45B) Inside of car ,facing door rear edge & B pillar..Whats the gap between the door shell rear edge to the B pillar... Interested in @top ,@ lock area,and bottom...Logic says it should be even , but would appreciate some real world measurements... If someone has a car with good fitting doors could measure the inside gap for me ,I would greatly appreciate it I'm trying to verify fitment before I fasten anything permanently.. Thanks , Stan Last edited by Turbo26T; 01-23-2019 at 04:41 PM.

01-21-2019, 03:33 PM	#2
Bob C Senior Member Join Date: May 2010 Location: So Cal Posts: 8,749	Re: '30-'31 Coupe inside door to B pillar gap This might help a little. http://www.fordgarage.com/pages/bodymeasurements.htm Bob

01-21-2019, 05:11 PM	#3
Turbo26T Member Join Date: Feb 2013 Posts: 57	Re: '30-'31 Coupe inside door to B pillar gap Sponsored Links (Register now to hide all advertisements) Bob: Thanks for the reply...I'm aware of those measurements and they are not what I need to verify some fitment issues.. I have searched the archives and have read /seen the normally referred to threads Stan Last edited by Turbo26T; 01-21-2019 at 05:24 PM.