|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
09-23-2011, 01:25 PM | #26 |
Senior Member
Join Date: May 2010
Location: Gwynn's Island Va
Posts: 1,386
|
Re: Milling a head for compression?
Sponsored Links (Register now to hide all advertisements)
Put the A on 4 jack stands. Spin a front wheel and time it. How long did it spin? 15sec...1 min...2 min? Now spin the other wheel. Whats the difference in the times? If you only get 15-30 sec then your using up engine HP to move the car. Get the wheel to spin for 1-2 min. and you will feel the difference. Same thing with tires. Take your Bicycle and set the air pressure at 15psi and ride it...now up the tire pressure to 40psi and go for a ride...feel the difference? I could take a Kart and give it a push in the garage and it might roll 3ft....remove as much friction as possible and push the kart....across the floor and out the door she would go! I hope this information is usefull. Wick |
|
|
Sponsored Links (Register now to hide all advertisements) |
|