|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
08-07-2012, 05:36 PM | #21 |
Senior Member
Join Date: May 2010
Location: So Cal
Posts: 8,732
|
Re: Steering worm gear install
Thanks James
Bob |
08-08-2012, 07:29 AM | #22 |
Senior Member
Join Date: May 2010
Location: Princeton, NJ
Posts: 965
|
Re: Steering worm gear install
You can also temporarily weld a couple of pieces of material to the shaft to press against:
http://www.dougbraun.com/model_a_gal...rakes/IMG_5818 Doug
__________________
My '31 S/W sedan project:http://31ford.dougbraun.com My restoration diary: http://dougbraun.com/blog |
Sponsored Links (Register now to hide all advertisements) |
|
08-15-2012, 06:25 PM | #23 |
Senior Member
Join Date: May 2010
Location: Sydney, Australia
Posts: 108
|
Re: Steering worm gear install
I used the clamp block suggested by James Rogers and a press and the job was very simple and successful and I still wouldn't use the tapping method and definitely not the welding method, sorry.
Robert1936 |
Thread Tools | |
Display Modes | |
|
|
Sponsored Links (Register now to hide all advertisements) |
|