Go Back   The Ford Barn > General Discussion > Model A (1928-31)

Sponsored Links (Register now to hide all advertisements)

 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
Old 09-23-2011, 01:25 PM   #26
Wick
Senior Member
 
Wick's Avatar
 
Join Date: May 2010
Location: Gwynn's Island Va
Posts: 1,243
Default Re: Milling a head for compression?

Sponsored Links (Register now to hide all advertisements)
Heres some FREE HP,I learned this in kart Racing in the 80's.
Put the A on 4 jack stands. Spin a front wheel and time it. How long did it spin?
15sec...1 min...2 min? Now spin the other wheel. Whats the difference in the times?
If you only get 15-30 sec then your using up engine HP to move the car. Get the wheel to spin for 1-2 min. and you will feel the difference. Same thing with tires.
Take your Bicycle and set the air pressure at 15psi and ride it...now up the tire pressure to 40psi and go for a ride...feel the difference? I could take a Kart and give it a push in the garage and it might roll 3ft....remove as much friction as possible and push the kart....across the floor and out the door she would go!
I hope this information is usefull.
Wick
Wick is offline   Reply With Quote
 

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 01:21 PM.