Rebuilding Fuel Valve Question

[Steve_KS]

I am rebuilding my fuel shutoff valve, it's not an original piece but a reproduction. I have the cone and body lapped together well enough I think but my question is on assembly. The rebuild kit has a packing nut, I didn't see one in the valve I disassembled.



Mine was the cone (brass piece with the 2 holes) then an O ring, washer, spring, washer, compression nut, then the handle, washer, and nut. I have a feeling the O ring and spring replaced the packing?



Just want to verify before I test it with gas in the tank.


Thanks