The Ford Barn

Fred · 05-28-2011, 05:17 PM

I need some recomnendations on some one REALLY good @ repairing a one line, tight, crack/split through a VERY EARLY Script Drum Brass tail light housing..

frankvflorida · 05-28-2011, 05:52 PM

Maybe a jeweler? He might want a challenge and something different.

Rowdy · 05-28-2011, 06:04 PM

Brent Terry has mentioned taking them to a musical instrument shop. They are more accustomed to working on Brass. I have not taken my brass teacups to one yet, but am planning on it when I get far enough along that it is feasable to. Rod

CWPASADENA · 05-28-2011, 06:34 PM

Sponsored Links (Register now to hide all advertisements)

Look for a shop that does repair and re-plating of Silver Service. (Tea Sets etc.) Normandy Plating here in Pasadena Ca. does this kind of work and they also do Nickel Plating.

I have repaired this kind of thing my self using Silver Solder and a VERY SMALL torch. It is easy to use and polishes out well and will plate with no problems. This is very common with the old brass parts that were formed from sheet. The brass will work harden with age and develope cracks.

Chris.

05-28-2011, 05:17 PM	#1
Fred BANNED Join Date: May 2010 Location: California, Maryland Posts: 1,421	"a" brass work I need some recomnendations on some one REALLY good @ repairing a one line, tight, crack/split through a VERY EARLY Script Drum Brass tail light housing..

05-28-2011, 05:52 PM	#2
frankvflorida Junior Member Join Date: May 2010 Posts: 17	Re: "a" brass work Maybe a jeweler? He might want a challenge and something different. __________________ www.franksvickie.webs.com Rust to Riches, a story about a boy and his car.

05-28-2011, 06:04 PM	#3
Rowdy BANNED Join Date: May 2010 Location: Gothenburg Nebraska Just off I-80 Posts: 4,893	Re: "a" brass work Brent Terry has mentioned taking them to a musical instrument shop. They are more accustomed to working on Brass. I have not taken my brass teacups to one yet, but am planning on it when I get far enough along that it is feasable to. Rod __________________ Do the RIGHT thing - Support the H.A.M.B. Alliance!!!!

05-28-2011, 06:34 PM	#4
CWPASADENA Senior Member Join Date: May 2010 Location: PASADENA, CA Posts: 1,884	Re: "a" brass work Sponsored Links (Register now to hide all advertisements) Look for a shop that does repair and re-plating of Silver Service. (Tea Sets etc.) Normandy Plating here in Pasadena Ca. does this kind of work and they also do Nickel Plating. I have repaired this kind of thing my self using Silver Solder and a VERY SMALL torch. It is easy to use and polishes out well and will plate with no problems. This is very common with the old brass parts that were formed from sheet. The brass will work harden with age and develope cracks. Chris.